Wikusama.com – Widyaloka Kusuma Samekta Makarya

I want to make point-to-point subinterface with Frame-Relay encapsulation in main link serial interface but there is a little confuse, here is

R3(config)#int s1/0
R3(config-if)#encapsulation frame-relay
R3(config-if)#int s1/0.1 poin
R3(config-if)#int s1/0.1 point
R3(config-if)#int s1/0.1 point-to
R3(config-if)#int s1/0.1 ?
% Unrecognized command

R3(config-if)#do sh run int s1/0
Building

Read original post at http://awanetwork.blogspot.com/2007/11/frame-relay-point-to-point-with.html

Related posts:

1. Frame-Relay Subinterface 'cannot change link type' (part 2)
2. Frame Relay Hub-Spoke without Mapping between Spoke
3. Simple backup, Primary and Secondary Link
4. Not all config may be removed and …
5. Cisco Back to Back Line AUX Ports
6. Linux Box Terminal via Serial Cable Console
7. Command dasar untuk router CISCO dan HUAWEI
8. Procedures for Configuring Interfaces These general instructions apply to all interface configuration processes.
9. BGP is clever (% BGP : incorrect network or mask configured)
10. 3 days before mission ‘going to CCIE’