Wikusama.com – Widyaloka Kusuma Samekta Makarya

I want to corection last posting about Frame-Relay Subinterface ‘cannot change link type’. Last posting I mention about solution ‘Now to solve this problem make default configuration subinterface, do write memory and reload the router’. The solution to this problem should be :
- make disable subinterface with ‘no interface s1/0.1′
- do ‘write memory’ save configuration to startup-config
- reload

Read original post at http://awanetwork.blogspot.com/2007/11/frame-relay-subinterface-cannot-change_02.html

Related posts:

1. Frame-Relay Point-to-point with '% Unrecognized command'
2. Frame Relay Hub-Spoke without Mapping between Spoke
3. Not all config may be removed and …
4. Simple backup, Primary and Secondary Link
5. Network Time Service Cisco Router
6. Procedures for Configuring Interfaces These general instructions apply to all interface configuration processes.
7. BGP is clever (% BGP : incorrect network or mask configured)
8. 3 days before mission ‘going to CCIE’
9. 3 days before mission 'going to CCIE'
10. Vlan VTP Client doesn’t updated